Reasons and solutions for problems in plastic shredders Common causes and solutions for non-standard products in large plastic shredders.

Common reason 1:
(1) Because the extruder screw or traction belt of the small plastic shredder waste plastic granulator is unstable in operation, the diameter of the plastic strip is uneven.

(2) Because the traction belt of the waste plastic pellet machine is suddenly unstable, the plastic strip is in the shape of bamboo.

(3) The mesh of the engine inlet and outlet of the waste plastic granulator is not uniform due to production processing or damage, and the diameter of each belt changes greatly.







Common reason 2:
(1) The speed of the traction belt of the waste plastic pellet machine is uneven.

(2) Because the traction belt of the waste plastic pellet machine is suddenly unstable, the installation of the large tractor is difficult.

(3) The screw speed ratio of the extruder of the waste plastic pellet machine is unstable, the rated power of the main motor is uneven, and the transmission belt is too loose or deviated.

Clear way:
(1) Check whether the screw speed of the extruder and the speed of the traction belt are uniform from beginning to end.

(2) Always check the size of the round hole screen at the entrance and exit of the engine.

(3) Check the operation status of machinery and equipment frequently, and repair the problems of milling workers and electric welders immediately.